Why does data centre cable management start above the racks?
Because density and change are built into the brief. The Netherlands had more than 1.5 GW of IT capacity in data centres at the end of 2025 (Dutch Data Center Association, 2026). In Amsterdam, 927 MW was operational in Q2 2026, with 102 MW under construction and 251 MW planned (Cushman & Wakefield). Growth is moving to locations such as Eemshaven and Middenmeer. Every new hall means hundreds of brackets, and every bracket a bill of materials.
How should you divide the tiers?
A common layout puts power on a cable ladder on one tier and copper and fibre in cable baskets on another, with 300 mm between tiers as a rule of thumb. Fibre gets its own run where possible, so heavy cables do not press on it. Above the cold aisle, keep space clear for sprinklers and lighting.
| Tier | Containment | Cables | Watch |
|---|---|---|---|
| Top | Cable ladder 500×100 | Power 5G16 | Rungs for tying, room for heat |
| Middle | Cable basket 400×60 | Cat6A S/FTP | Fill max. 40% at installation |
| Bottom | Cable basket 300×60 | OM4 and OS2 trunks | Own tier, protection at bends |
How do you keep power and data segregated?
With separate tiers or a divider in the containment, following the applicable IEC and national standards. The configurator shows a red status when power and data share a run without a divider. The enquiry still goes through, with a clear warning for the job preparer.
What does a trapeze above the racks carry?
The load per bracket is the weight of all containment and cables per metre, multiplied by the support spacing, shared over two threaded rods. Then check the rod, the anchor or beam clamp and the soffit. The configurator calculates this indicatively per bracket; the manufacturer confirms at quotation. Where circuit integrity in fire is required, tested systems and lower loads apply; check them with the manufacturer.
Why prefabrication in data centres?
Data centre builders increasingly work offsite, because fitters are scarce and programmes are tight. Trapezes and frames are assembled in a workshop and delivered per position on pallets. That needs a drawing and bill of materials per position: exactly what the configurator produces.
Frequently asked questions
Which containment is used for data cables in a data centre?
Usually cable basket above the racks: light, open and easy to adapt. For heavy power cables over longer spans, choose cable ladder.
How much space should you leave between tiers?
300 mm as a rule of thumb, so cables can be laid and air can move around them. Soffit height, sprinklers and lighting set the final dimension.
Can fibre share containment with power?
Electrically yes, fibre is immune to interference. Mechanically it is a risk: heavy cables can kink or crush fibre. Give fibre its own tier or run where possible.
Can the configurator deliver prefab brackets per position?
The configurator produces a drawing, bill of materials and cutting list per position. Assembly is done by your workshop or an assembly partner.