What are roof supports used for?
For anything that has to sit on a flat roof without penetrating it: cable routes to solar panels, pipework from cooling plant, condensers and air handling units, and walkways. An H-frame on roof blocks lifts a route clear of the roof so water drains freely.
What should you watch?
A roof block presses on the membrane and the insulation below. The compressive strength of the roof build-up and the weight per block set how many blocks you need. Use a protection layer under the block if the membrane manufacturer requires it, and allow for wind load on tall items. The configurator calculates indicatively; a structural engineer or the roof manufacturer confirms.
- Block about 200 × 200 mm, rubber or plastic
- Channel 41×41 or 41×21, HDG outdoors
- Height adjustable with threaded rod or an upright
- Block spacing according to load and channel
Which finish for outdoors?
Hot-dip galvanised (HDG) is the outdoor standard. In salt-laden or aggressive environments choose stainless steel. Pre-galvanised material is meant for dry indoor areas and corrodes faster outdoors.
Frequently asked questions
Do you have to penetrate a flat roof for a cable route?
Not with roof supports: they sit loose on the roof and carry the load by gravity. The membrane stays watertight.
How much does a roof support block weigh?
That varies by manufacturer and type. Ask your supplier for the data; the client version of the configurator uses it.
Can an HVAC unit stand on roof supports?
Yes, on a strut frame on roof blocks. Check weight, vibration and wind load with the unit manufacturer.